10" Dual 2.5" SSD & Hard Drive Mini Rack Mount - 1U

Fits any two standard 2.5" SSDs or hard drives side by side in a 10" mini rack, using just 1U. Each drive screws in through the side mounting holes every 2.5" drive has, so thin 7 mm SSDs with no bottom holes fit just as well as thicker laptop drives.

CONFIGURATIONS

• Patterned: a diagonal lattice vent in front of each drive for airflow
• Solid: a clean, closed front panel

FITS

• Any standard 2.5" SATA SSD or hard drive from 5 mm to 15 mm thick (SFF-8201 form factor)
• Drives with bottom holes can use those too
• SATA connectors face the back, so cables plug straight in

⚠️ Before you order and install: this holds 2.5" drives with a metal or plastic case. M.2 and mSATA SSDs are bare circuit boards with no mounting holes and will not fit.

WHAT YOU GET

• One 1U mount with two drive trays, printed as a single piece
• Eight M3 x 5 mm pan head drive screws, four per drive
• Not included: drives or rack screws

MATERIAL
3D printed in PETG for better heat tolerance than PLA in a warm rack. Each drive sits on raised pads over a vented tray floor so air can move around it.

A version for two 3.5" hard drives is also listed in my shop. 💬 For any custom design requests please message me.