19" HP Z2 Mini G1a Workstation Rack Mount - 3U (Modular)

Fits the HP Z2 Mini G1a Workstation in a 19" rack at 3U, with the whole rear I/O panel facing out the front of the rack. Order it as a single with a blank half, or as a double that holds two of them side by side.

CONFIGURATIONS

• Single Mount: one cage for one Z2 Mini G1a, plus a blank half that fills out the rest of the rack row.
• Double Mount: two cages on one panel, so a pair of G1a units share a single 3U row.

FITS

• HP Z2 Mini G1a Workstation

⚠️ Before you order and install:

• Check the label on your machine says Z2 Mini G1a. The Z2 Mini G1i is a different chassis and will not fit this mount, and the older Z2 Mini G3, G4 and G5 have their own mount in my shop.

WHAT YOU GET

• Both halves of your chosen configuration, plus the joining screws and heat-set inserts.
• Rack screws are not included. Use whatever your rack takes.

MODULAR
This is part of my Modular Series. The single arrives with its blank half already, so it fills the full rack row the day it lands. Swap that blank later for any other Modular Series mount and run two different devices in one row. Pieces pair within the same U height, so a 3U joins a 3U.

MATERIAL
3D printed in PETG, not PLA. The G1a runs a 300 watt supply inside a small box and pushes that heat straight out the back, so the mount needs a plastic that holds its shape where PLA would start to soften.

A 10" mini-rack version is also listed in my shop. 💬 For any custom design requests please message me.