19" Beelink EQi 304 Mini PC Rack Mount - 2U (Modular)

The Beelink EQi 304 puts 10GbE, dual Thunderbolt 4, and a built-in power supply into a small square chassis, which makes it a genuinely useful homelab node. This mount gets it into a 19 inch rack instead of sitting on a shelf behind one. Good for Proxmox nodes, NAS front ends, and always-on small servers where you want the machine racked and reachable.

Compatible with: Beelink EQi 304 (Intel Core 3 304, Wildcat Lake).

Available in 2 configurations:

• Single Mount (1x): one EQi 304, paired with a blank half that fills the rest of the rack width
• Double Mount (2x): two EQi 304 units side by side across the full 19 inches

The mount is modular, so the two halves bolt together at the seam and the front panel keeps the front USB ports, audio jack, and power button reachable from the front of the rack. The open lattice above and below the device lets the built-in 85W supply and the 10GbE controller breathe, which matters more on this machine than on a typical low power box.

⚠️ Important: take the four rubber feet off the bottom of the EQi 304 before fitting it. The cage is sized to the bare chassis, so the feet need to come off for the unit to seat properly.

You get the printed mount and the hardware that joins the halves together. Rack mounting hardware is not included, so use whatever your rack uses.

I 3D print this in PETG rather than PLA because the EQi 304 carries its power supply inside the chassis and pushes real heat into the rack, and PETG holds its shape in a warm enclosure far better than PLA does. A 10 inch mini-rack version is also listed in my shop.

💬 For any custom design requests please message me.